Features
• Utilizes the AVR® RISC Architecture
• AVR – High-performance and Low-power RISC Architecture
– 120 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
– Up to 20 MIPS Throughput at 20 MHz
• Data and Non-volatile Program and Data Memories
– 2K Bytes of In-System Self Programmable Flash
Endurance 10,000 Write/Erase Cycles
– 128 Bytes In-System Programmable EEPROM
Endurance: 100,000 Write/Erase Cycles
– 128 Bytes Internal SRAM
– Programming Lock for Flash Program and EEPROM Data Security
• Peripheral Features
– One 8-bit Timer/Counter with Separate Prescaler and Compare Mode
– One 16-bit Timer/Counter with Separate Prescaler, Compare and Capture Modes
– Four PWM Channels
– On-chip Analog Comparator
– Programmable Watchdog Timer with On-chip Oscillator
– USI – Universal Serial Interface
– Full Duplex USART
• Special Microcontroller Features
– debugWIRE On-chip Debugging
– In-System Programmable via SPI Port
– External and Internal Interrupt Sources
– Low-power Idle, Power-down, and Standby Modes
– Enhanced Power-on Reset Circuit
– Programmable Brown-out Detection Circuit
– Internal Calibrated Oscillator
• I/O and Packages
– 18 Programmable I/O Lines
– 20-pin PDIP, 20-pin SOIC, 20-pad QFN/MLF
• Operating Voltages
– 1.8 – 5.5V (ATtiny2313V)
– 2.7 – 5.5V (ATtiny2313)
• Speed Grades
– ATtiny2313V: 0 – 4 MHz @ 1.8 - 5.5V, 0 – 10 MHz @ 2.7 – 5.5V
– ATtiny2313: 0 – 10 MHz @ 2.7 - 5.5V, 0 – 20 MHz @ 4.5 – 5.5V
• Typical Power Consumption
– Active Mode
1 MHz, 1.8V: 230 μA
32 kHz, 1.8V: 20 μA (including oscillator)
– Power-down Mode
< 0.1 μA at 1.8V

深圳的朋友可直接到实体店参观洽谈

门市地址： 深圳市福田区华强北路赛格广场二楼2580# Address： Uint 2580,2/F,SEG Plaza,Huaqiang North Road,Shenzhen 电话(Tel)： 0755-8368 1282(2Line) 信琪网址： http://www.xinqi.cn 销售邮箱： sales@xinqi.cn 旺旺在线： 在线qq：    e-mail： icsales@hotmail.com 邮政编码： 518031

温馨提示：

网上标价均为参考单价，少量或样品请联系客服，如有不便，敬请谅解！

集成电路电子零件是专业电子产品，技术含量较高，由于本身可能存在着多种品牌，与封装，所以可能存在参数与性能的差异，有的产品是以最小包装或者没开包装整包装出售等问题，请您在购买前， 请将您所需要的产品型号 品牌、封装，规格等要求我们的销售人员联系，落实确认后，再进行交易！